10
• System 8
1. Split the single wire down to approx. 30 mm on both
ends and strip approx. 10 mm of insulation off of each
cord. Twist the single wire together so that no strands are
protruding.
2. Turn the connector terminal counterclockwise until
loose. Run the stripped cable end into the now visible
hole. Close the terminal by turning it counterclockwise.
The cable has now been clamped in place.
3. Connect all cables to the speakers this way.
4. Connect the speaker cables to your AV receiver. The
operating instructions of the appliance should contain
notes on this.
Connection to a power supply
1. Ensure that the mains switch
6
“Power” on the sub-
woofer is switched off (“0 OFF” position).
2. Connect the mains connector jack
7
with a mains
socket using the mains cord
햶
.
3. Also plug the mains plug of your AV receiver back into
the socket.
6
7
91446 GB 20111209.indd 10
91446 GB 20111209.indd 10
14.12.11 13:59
14.12.11 13:59
