7
• Definion 5 – High End Floor Speakers
Care and cleaning
• Ideally, you should remove dust or small amounts of
dirt with a dry, smooth leather cloth.
• Rub off stubborn dirt with a damp cloth. Make sure
that no liquid penetrates the speakers.
• Then immediately wipe the surfaces dry with a soft
cloth without applying pressure.
Attention
Risk of damage
!
Using the wrong cleaning materials may dam-
age the delicate surface of the case.
• If possible, only use plain water without any additives.
In case of stubborn marks, a mild soap solution may
be used.
• In no circumstances should caustic cleaning products,
white spirit, thinners, petrol or similar be used for
cleaning.
Connecting the cables
1. Turn off your amplifier/AV receiver.
2. Lay the speaker cables from your amplifier/AV receiver
to each of the speakers. Use a high-quality double
wire speaker cable with marked strands for this.
3. A connector terminal with four
terminal clips is located on the
back side of each speaker. You
can connect the speaker cables
directly here or using pin plugs.
The terminals are marked in red (+) and black(-).
Make sure the polarity is correct!
Connect the like coloured terminals. The
speaker connections of your amplifier should
be marked similarly. The strands of the speaker cables
are marked with different colours or shapes.
4. If you use speaker cables with
pin plugs or cable sockets from
our assortment, simply insert
the pin plugs in the upper or
lower connector terminals.
5. The cable sockets are also
mounted on the upper or lower
terminals.
6. If you use speaker wires without
plugs, split the wire down to
approx. 30 mm on both ends
and remove approx. 10 mm
of the insulation on each end.
Twist the wire so that no strands
are protruding.
7. Turn the connector terminal
counterclockwise until loose.
Run the stripped cable end into
the now visible hole. Close the
terminal by turning it counter-
clockwise. The cable has now
been clamped in place.
8. You only have to remove the
cable bridges
and con-
nect the connector terminals individually for
bi-wiring
or
bi-amping operation
.
To do this, loosen the connector terminals by turning
them counterclockwise and pull the cable bridges out.
The upper terminals lead to the high and medium
range path and the bottom terminals lead to the low
range path.
9. Connect the other end of the speaker cables to your
amplifier/AV receiver. You should be able to find cor-
responding notes in the operating instructions of your
device.
10. Turn your amplifier/AV receiver back on.
