7
• Definion 3S
Connecting the Speakers
The Definion 3S speakers are delivered with-
out speaker cables due to different customer
requirements. Suitable cables are available in our
webshop (www.teufelaudio.com) under the “Accesso-
ries” category.
• On the back of the speakers are the connection
terminals, with 2 terminal clips. You can connect
the speaker cables here directly or with banana
plugs or spade terminals from our catalogue. The
terminals are marked in red (+) and black(-).
Make sure the polarity is correct!
Connect the like-coloured terminals together,
otherwise the sound quality will suffer. The speak-
er terminals of your amplifier should be similarly
marked. The individual speaker cables are marked
with different colours or shapes.
1. Turn off your amplifier/AV receiver.
2. Lay the speaker cables from your amplifier/AV
receiver to each of the speakers.
3. When you use speaker cables with banana plugs or
spade terminals from our catalogue, simply insert
the banana plug into the terminal with the
matching colour.
Spade terminals are pushed under the connector
terminals and then tightened.
4. If you use speaker wires without plugs, split the
wire down to approx. 30 mm on both ends and
remove approx. 10 mm of the insulation on each
end. Twist the wire so that no strands are
protruding.
5. Turn the connector terminal counterclockwise until
loose. Run the stripped cable end into the now visi-
ble hole. Close the terminal by turning it clockwise.
The cable has now been clamped in place.
6. Connect the other end of the speaker cables to
your amplifier/AV receiver. You should be able to
find corresponding notes in the operating
instructions of your device.
7. Turn your amplifier/AV receiver back on.
