• Cinebar 21
11
Basic functions
Cinebar 21
Activating and deactivating
• With the
Power (1)
button or
(22)
, you can switch
your
Cinebar 21
on or to standby. The standby indica-
tor
(5)
will illuminate in red in standby mode.
Selecting a source
Also see page 10, table 1.
• Push the device button
Source (2)
until the connector
jack of the desired source appears on the display.
• On the remote control, select the source with the but-
tons
Aux (32)
or
Optical (23)
or
Coaxial (25)
.
The respective setting will appear on the display.
Adjust the volume
• On the device: Push the buttons
Vol +/– (3)
.
• Using the remote control: Push the
b/– (30)
.
Mute (switching to mute)
• You can activate or deactivate the sound by pushing
the button
(24)
repeatedly.
Remote control
The battery
An insulating strip has been affi xed between the battery
and the contact in order to preserve the entire battery
capacitance for delivery. Simply pull this strip out.
Changing the batteries
The battery should be replaced if the remote control stops
functioning properly or no later than after 2 years. Bat-
tery type: CR 2025 LITHIUM BATTERY.
Remove the battery compartment cover from the remote
control and replace the batteries in order to change the
batteries.
Make sure that the polarity is correct!
Danger
Danger of explosion!
Lithium batteries can explode if handled im-
properly.
• Never attempt to charge the lithium battery.
• Only insert a battery of the same or equivalent type.
• Do not heat, short circuit or dispose of the battery in
fi re.
Do no subject the batteries to direct sunlight.
22
24
25
30
32
23
92014 GB 20120207.indd 11
92014 GB 20120207.indd 11
07.02.12 10:43
07.02.12 10:43
