Assembly
[
⑥ ⑦
①
②
③
④
M
[
⑤
1. Screw the pipe
②
on the base plate
①
using four screws
⑥
and four washers
⑦
. The big hole on the upper end is
the cable feedthrough which should point to the back.
2. Run the speaker cable through the upper hole and through
the pipe until it extends somewhat out of the opening in
the base plate. Then pull it through until there is suffi cient
length left for connecting the speaker at the top.
3. Screw the speaker bracket
③
on the speaker from below
using the screw
④
. The
M
mark must point to the front in
the process.
4. Place the speaker with the speaker bracket on the pipe
and screw the bracket on the pipe through the bore holes
using two screws
⑤
.
5. Connect the speaker cables as described in the operating
instructions for the speakers.
