Synchronising The Remote To Receiver
Page 3
Please Note:
All controllers & receivers sold in a pack are pre-synchronised. There is no need to sync the
remote to the receiver.
*Only follow the instructions below if you are adding another receiver with the same remote
NOTE:
Steps 2 & 3 must be conducted within 2 seconds. Make sure power to the receiver is switched
off before step 1
Insert 2 x AAA working batteries in the remote. This will ensure the Remote is powered up.
Turn ON the power to the Driver / Receiver. (depending on which accessory the Strip is
connected to.
1) Ensure the Remote has power
2) Turn the LED Strip ON
3) Press the “high brightness” button on the Remote.
4) The LED Strip will flash twice if the synchronisation is successful.
5) Just repeat the learning process to synchronise several receivers to the same controller.
6) To clear the synchronisation, simply press the “High Brightness” button three times after switching
on the LED Strip.
on
off
High Brightness
