1 Zone RF Remote Control
for RGB and RGBW LED strip
www.teucerled.co.uk
V002-11-2019
Synchronising the remote to receiver
1)
Ensure the receiver has power. Press the match button on the receiver. Indicator will start flash-
ing.
3)
To restore to factory default settings and delete the allocated
controller, press and hold the match button longer than 5
seconds.
2)
Press any button on the remote to allocate the receiver within 5 seconds after pressing the
match button. The LED indicator on the receiver will flash rapidly 5 times and then stop flashing.
The controller is now synchronised with the receiver.
Press any button to
allocate
the receiver
Troubleshoot
Problem
Cause
Corrective
No light
• No power.
• Wrong connection or unsecure
connection.
• Check the power.
• Check the connection.
Wrong Colour
• Wrong connection of RGB/W wires. • Re trace and reconnect
RGB/W wires.
Uneven intensity
between front and
rear of the strip,
with voltage drop
• Output cable is too long.
• Cable diameter is too small.
• Overload beyond driver capability.
• Overload beyond receiver capability.
• Reduce cable or loop supply.
• Change to a thicker cable.
• Replace with a suitable higher
power driver.
• Add a power repeater.
No response
from the remote
• The battery has no power.
• Beyond controllable distance.
• The controller isn’t synchronised
with the remote.
• Replace battery.
• Reduce remote to receiver
distance.
• Re-sync the remote.
Match button
LED indicator
Pu
sh
-D
im
G
ND
R4C
Match button
LED Indicator
R3C
