INSTALLATION AND OPERATING INSTRUCTIONS
H20-GSD4C
D. SANITATION
WARNING:
Turn off power and unplug unit before cleaning.
It is recommended the
fi
lter bottle disassembled and cleaned
periodically. Filter cartridge should be replaced every 600 litres
or 6 months, whichever occurs
fi
rst, to ensure
fi
lters performs as stated.
If water has been left sitting in unit for more than 5 days, discard
water and
fl
ush out unit.
1. Mix 6 table spoons of sanitizing solution with 1 litre of cold water.
Remove the
fi
lter cartridge then pour mixture into
fi
lter bottle. Hold
down the cold tap to ensure mixture
fi
lls the cooling tank. Leave for
at least 1/2 an hour.
The sanitising solution is available from H2O International,
call 0800 49 28 37 or visit www.h2o.co.za for your nearest outlet.
2. Drain out mixture then
fl
ush 2 - 3 L clean water through the unit
until it has been
fl
ushed clean.
Note:
Empty tank by unscrewing the drain plug cap at the rear of the
unit. Make sure to drain over a sink, water will immediately come out
upon unscrewing the plug. Completely empty the tank by tilting the
unit back and forth to remove all trapped water. Continue this
process until no more water runs out of the drain.
Press both taps to remove water in taps.
4. Remove
fi
lter bottle and wash thoroughly with warm soapy water.
WARNING: When the
fi
lter bottle is removed the Filter bottle O ring
may remain in the top of the water cooler.
Always ensure this piece is correctly seated on the base of the
fi
ltered
water chamber prior to installing the
fi
lter bottle otherwise leaking
may occur. See
fi
gure 1. on page 5.
5. Replace the
fi
lter cartridge if necessary.
6. Repeat steps 2 -12 in the operations instructions.
Do not hesitate to contact our Customer Care Service line
on 0800 49 28 37 or info@[email protected]
FILTERED WATER COOLER NOT USED FOR LONG PERIODS
If the Elegant Filtered Water Cooler will not be used for a long period
of time unplug the unit from the wall socket. Remove the
fi
lter bottle
from the unit and clean with warm soapy water. Empty the water
cooler by draining all water from the taps and via the drain plug and
dry the unit.
