14
The heater should not be installed if there are other heat sources with
temperature above 80°C.
4.3 Install the heater
Installation of the heater on a flange on the lower side of the boiler
1 Remove the plastic cover from the flange(5)
2 Use the template of the heater set to cut an
opening into the plastic cover (6) and the
polyurethane insulation (4).
3 Install the plastic cover with its insulation
4 Install the heater as you observe above
requirements.
Power cord should always be directed
towards floor.
5. Operation
These models of heaters are equipped with a thermo regulator, which automatically maintains
the temperature in the boiler. The thermo regulator is located in plastic cover of the heater.
Before using the water heater make sure that the appliance is connected with the heating
installation in correct way and is filled with water.
5.1 Temperature adjustment.
These models of heaters equipped with a thermoregulator, which automatically maintains the
temperature in the boiler. The thermoregulator is located in the plastic cover of the heater
1.
By turning the switch in the direction of “+” (MAX) you increase the temperature.
2.
By turning the switch in the direction of “-“ (MIN) you decrease the temperature.
3.
When the red indicator lamp is on the heater is operating and is heating up the water.
4.
When the lamp turns off the heater is not operating and does not heat the water.
5.2 Temperature overheating protection
The appliance is equipped with a device (thermal switch) for water overheating protection. It
disconnects the heater from the main electrical system when the temperature reaches too high
values.