Automatic
Vicat Needle Apparatus
1.0306
16
4.
Set the distance between the needle and the surface of the Vicat ring by using the
magnets (see arrow 4 in drawing below).
5.
Set the lower distance between the needle and the surface of the glass by using
the limit stop (arrow 5 in drawing below).
4.
Maintenance and cleaning
Please get directly in contact with the manufacturer in case of any special maintenance
work that may become necessary: for example, repairs, exchange of parts, and all other
tasks that are not described in this Operating Manual.
The Automatic Vicat Needle Apparatus needs practically no maintenance. After several
years of use, we recommend cleaning the system thoroughly and lubricating the moving
parts.
It may become necessary after using the Operating Manual for a long period of time, or
using it in dirty surroundings, to clean the outside the system. Please proceed as follows:
1. Switch off the main power switch of the system.
2. Unplug the system from the power supply.
3. Use a brush or a vacuum cleaner to remove any dust that may lie loosely on the sur-
face of the device. If necessary, you can clean the outside of the unit with a moist
cloth. You can also use normal household cleaning agents if required.
Attention
Do
NOT
use forced water, rushing water, gushing water, or spray wa-
ter to clean the Automatic Vicat Needle Apparatus. Also do not use
dripping sponges or other unsuitable cleaning agents to clean the sys-
tem. If water enters the controller unit by using such unsuitable clean-
ing methods, this will result in permanent damage to the mechanical,
electronic, and/or electrical components of the system.
All maintenance or repair work involving components of the Automatic
Vicat Needle Apparatus or its electrical system must be performed by
suitably qualified specialists.
Magnet for end
of solidification
5
Magnet
for 50mm
needle
4
