© TPI Europe 2021
12 TPI 9085 User Guide V1.0
Factory Reset
will reboot the 9085 and set all parameters back to factory defaults.
The
Graph Mode
can be set to display the frequency spectrum as either a
Line
graph or
a
Bar
graph.
The display
Color Scheme
can be configured as standard (full
colour) or monochrome, e.g. for convenient viewing in direct
sunlight.
Date & Time
setting can be achieved using the up, down, left and
right arrow buttons.
Selecting
Units
from the Device Settings menu allows the velocity readings to be
displayed in either mm/s or inch/s. Run Speed units can be displayed in units of Hertz
3
(Hz), revolutions per minute (RPM) or cycles per minute (CPM). The velocity type can be
selected between RMS and Peak. Displacement units can be set to Peak or Peak to
Peak. Temperature units can be set to Celsius or Fahrenheit.
Selecting
Temp Settings
enables several temperature parameters to be set.
Save with
Vib
can be enabled or disabled. When disabled the temperature reading will be displayed
only and not saved for download. When enabled, the temperature reading will be saved
with the vibration readings and transmitted to C-Trend software when the 9085 is docked.
Save Mode
can be set to Manual or Auto. In manual mode the 9085 will prompt you to
press the center key after the countdown timer goes to zero to save the temperature
reading. This can be useful if you would like to control when the reading is saved. In auto
mode the temperature reading will be saved automatically after the countdown. Use
Min
Save Time
to set the minimum countdown before the 9085 prompts you to save the
temperature reading. This can be set from 10s to 120s.
Auto Save Time
allows
adjustment of the time before the temperature reading is automatically saved. This can
be set from 10s to 120s.
Lock Device
immediately locks the 9085 to prevent unauthorized use. To unlock the
9085 turn the 9085 on and press the center key for several seconds until you are
prompted to enter the unlock code. The default unlock code is 375.
Lock Settings
locks out the ability to get into the menu to change settings without the
unlock code. In this mode the 9085 will still take readings but the menu is inaccessible
unless the unlock key is entered. To unlock and turn off this feature turn the 9085 on and
press the center key for several seconds until you are prompted to enter the unlock code.
The default unlock code is 375.
Information
displays the firmware version of the 9085 and the serial number.
Temperature Only Mode
displays only the temperature reading. Pressing and holding
the menu key puts the 9085 in temperature display only mode. Pressing the center
test key will return the 9085 to normal operation.
3
Hertz are equivalent to, and also sometimes referred to as, cycles per second (CPS).
