Remove the batteries by pressing down on the right side of the 4-pack battery holder so that the
left side of the holder will pop up. Pull out the holder and replace the batteries as needed.
When returning the holder, note the position of the spring clips inside the armrest housing and
make sure that the battery pack contacts fit snugly against the springs. Insert the side with the
contacts first and then press down on the left edge of the battery holder to reseat the holder.
Snap compartment cover to close.
ASSEMBLING YOUR DETECTOR
1.
On the lower pole assembly, remove the mounting screw and thumb nut from the pole
tip.
2.
Insert the pole tip between the mounting ears of the searchcoil and align the holes of the
pole tip and washers with those of the mounting ears.
Note: The pole tip should fit very snugly into the mounting ears.
