Tesla TSL-HC-U82RH, User Manual

Page: 10 / 136

10
Fitting the CUFF
1). Put the cuff on a table flatly with the velcro side
down. Pass The end of the cuff Through The metal
loop so that a circle is formed. The velcro closer will
now be facing outwards (ignore
this step if the cuff has already been prepared).
2). Push The cuff over the left upper arm so that the
tube points in the direction of the lower arm.
3). Wrap The cuff on the arm as illustrated. Make cer-
tain that the lower edge of the cuff lies approximately
2 To 3cm above the elbow and the rubber tube leaves
the cuff on the inner side of the arm.
4). Tighten The free end of the cuff and close the cuff
by affixing the velcro.
5). The cuff should be snug on your upper arm so that
you can fit 2 fingers between the cuff and your upper
arm. Any piece of clothing restricts the arm which must
be taken off.
6). Secure The cuff with the velcro closer in such a
way that it lies comfortably and not too tight. Lay your
arm on a table (palm upwards) so that the cuff is at the
same height as the heart. Do not bend the tube.
Note
If it is not possible to fit the cuff to your left arm, it can also be
placed on the right hand. However, all measurements should be
made using the same arm.