16
ENG
CAUTION!
Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent person
must do the troubleshooting that is not in this manual.
IMPORTANT!
There are some sounds during normal use (compressor, refrigerant circulation).
If the malfunction shows again, contact the Service Center. These data are necessary to help you quickly
and correctly. Write the necessary data here, refer to the rating plate.
TROUBLESHOOTING
Problem
Possible cause
Solution
Appliance does not work
Power plug is not plugged in or
is loose
Insert power plug.
Fuse has blown or is defective
Check fuse, replace if necessary.
Socket is defective
Socket malfunctions are to be
corrected by an electrician.
Appliance freezes too much
Temperature is set too cold
or the appliance runs at
MAX
setting.
Turn the temperature regulator
to a warmer setting temporarily.
The food is not frozen enough
Temperature is not properly
adjusted.
Please look in the initial
Temperature Setting section.
Door was open for an extended
period.
Open the door only as long as
necessary.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
Turn the temperature regulation
to a colder setting temporarily.
The appliance is near a heat
source.
Please look in the installation
location section.
Heavy build-up of frost on the
door seal
Door seal is not air-tight.
Carefully warm the leaking
sections of the door seal with
a hair dryer (on a cool setting).
At the same time shape the
warmed door seal by hand such
that it sits correctly
Unusual noises
Appliance is not level.
Re-adjust the feet.
The appliance is touching the
wall or other objects.
Move the appliance slightly.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
If necessary, carefully bend the
component out of the way.
Summary of Contents for RU1700H
