SWITCHING THE APPLIANCE OFF
When cleaning has finished, the appliance returns to the place where the cleaning started and alerts
you that it has finished with an audible signal.
1.
Press and hold the
button for a while.
The appliance will stop creating a vacuum and can be removed from the window.
2.
Remove the safety cable and suction cup.
3.
Disconnect the appliance from the mains.
4.
Drain the residual water from the appliance.
MAINTENANCE
WARNING! We recommend that you perform regular maintenance to ensure the most
efficient cleaning.
LACK OF MAINTENANCE MAY CAUSE DAMAGE TO THE APPLIANCE AND LOSS OF THE
WARRANTY.
Before performing cleaning and maintenance, switch off the appliance by holding down the
button and disconnect it from the mains.
1.
Turn the appliance over and remove the cleaning cloth. Soak it in warm water for 2 minutes,
wash it by hand with a mild detergent and allow it to dry completely before reattaching.
2.
Regular washing of the cleaning cloth will prolong its life. If the cleaning cloth wears out or no
longer fits properly in the Velcro area, replace it with a new one to ensure the best cleaning
effect.
3.
Wipe the top cover of the appliance with a soft, dry cloth. Wipe the bottom of the appliance, the
fan cover and the edge detection sensor.
CLEANING THE CATERPILLAR TRACKS
If the caterpillar tracks are dirty or wet, the appliance will not work properly on the window and the
tracks may slip.
Turn the appliance over, connect the power supply and press the directional button
on the remote
control three times with the appliance switched off Clean the dust from both tracks gradually with a
damp cloth. You can move the tracks along using the
button on the remote control. After cleaning
the caterpillar tracks, dry them thoroughly before using them again.
WARRANTY REPAIR
For warranty repair, contact the dealer where you purchased the TESLA product.
Summary of Contents for RoboStar W600
Page 1: ...TESLA RoboStar W600...
