11
ENG
Fix top bracket with
wooden cabinet.
Fit two guides with
sliders and fix them with
screws. Then fix guide
covers with guides.
9
Attached rubber seal to
the gap between unit and
wooden cabinet at door
open side.
Double check the door can
close and open smoothly
and appliance is sealed well.
If not, slightly adjust the unit.
Then fix bottom bracket with
wooden cabinet.
10
8
Positioning
Install this appliance at a location where the ambient temperature
corresponds to the climate class indicated on the rating plate of the
appliance:
for refrigerating appliances with climate class:
• extended temperate: this refrigerating appliance is intended to be
used at ambient temperatures ranging from 10 °C to 32 °C; (SN)
• temperate: this refrigerating appliance is intended to be used at
ambient temperatures ranging from 16 °C to 32 °C;(N)
• subtropical: this refrigerating appliance is intended to be used at
ambient temperatures ranging from 16 °C to 38 °C;(ST)
• tropical: this refrigerating appliance is intended to be used at
ambient temperatures ranging from 16 °C to 43°C;(T)
Location
The appliance should be installed well away from sources of heat
such as radiators, boilers, direct sunlight etc.
Cleaning the interior
Before using the appliance for the first time, wash the interior and
all internal accessories with lukewarm water and some neutral soap
so as to remove the typical smell of a brand new product, then dry
thoroughly.
IMPORTANT!
Do not use detergents or abrasive powders, as these
will damage the finish.
Temperature Setting
• Plug on your appliance. The internal
temperature is controlled by a
thermostat. There are 8 settings . 1
is warmest setting and 7 is coldest
setting and 0 is off.
• The appliance may not operate at
the correct temperature if it is in a
particularly hot or if you open the
door often.
WARNING!
It must be possible to disconnect the appliance from the mains
power supply; the plug must therefore be easily accessible after
installation.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown
on the rating plate correspond to your domestic power supply.
The appliance must be earthed. The power supply cable plug is
provided with a contact for this purpose. If the domestic power
supply socket is not earthed, connect the appliance to a separate
earth in compliance with current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility if the above safety
precautions are not observed.
This appliance complies with the E.E.C. Directives.
First use
DAILY USE
7
Slider
Guide
