15
ENG
CAUTION!
Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent person must do the troubleshooting that is not
in this manual.
IMPORTANT!
There are some sounds during normal use (compressor, refrigerant circulation).
TROUBLESHOOTING
Problem
Possible cause
Solution
Appliance does not
work
Temperature regulation knob is set at number “0”.
Set the knob at other number to switch on the appliance.
Mains plug is not plugged in or is loose.
Insert mains plug.
Fuse has blown or is defective.
Check fuse, replace if necessary.
Socket is defective.
Mains malfunctions are to be corrected by an electrician.
The food is too warm
Temperature is not properly adjusted.
Please look in the initial Temperature Setting section.
Door was open for an extended period.
Open the door only as long as necessary.
A large quantity of warm food was placed in the
appliance within the last 24 hours.
Turn the temperature regulation to a colder setting
temporarily.
The appliance is near a heat source.
Please look in the installation location section.
Appliance cools too
much
Temperature is set too cold.
Turn the temperature regulation knob to a warmer setting
temporarily.
Unusual noises
Appliance is not level.
Re-adjust the feet.
The appliance is touching the wall or other
objects.
Move the appliance slightly.
A component, e.g. a pipe, on the rear of the
appliance is touching another part of the
appliance or the wall.
If necessary, carefully bend the component out of the way.
Water on the floor
Water drain hole is blocked.
See the Cleaning section.
If the malfunction shows again, contact the Service Center.
