2
Powerwall Stack Kit Installation Manual
Powerwall Stack Kit Contents
•
(2) Side clips
•
(1) Top cover
•
(1) Conduit nipple
•
(2) Conduit insulation bushings
•
(2) Conduit sealing O-rings
•
(1) Bridge piece
•
(1) 5-conductor communication cable
•
(1) Wiring interface cover
•
(4) Magnetic camshaft caps
•
(1) 6 mm Allen wrench
•
(1) Drill guide (two pieces)
Required Tools
•
Personal protective equipment (safety glasses, gloves, protective footwear)
•
Drill and 6 mm (1/4-inch) drill bit (for drilling pilot hole in Powerwall chassis)
•
35 mm (1-3/8 inch) hole saw (for drilling conduit hole in Powerwall chassis)
•
Small metal file (for removing burrs from Powerwall chassis sheet metal)
•
Rubber mallet or small hammer and wood block (for seating side clips in Powerwall)
•
Wire strippers/cutters for 1.5 to 8 mm
2
(24 to 8 AWG) wires
•
Small grease applicator (wooden craft stick or cotton swab)
•
Water-resistant heavy-duty grease (Dow Corning Molykote BR-2 Plus High
Performance Grease or equivalent, for preventing corrosion on side clips)
•
Installation tools (level, tape measure, pencil, flashlight)