The acceleration settings available on your
Model S vary depending on date of
manufacture and options chosen at time of
purchase:
•
Chill
: limits acceleration for a smooth and
gentle ride (available on all vehicles
equipped with Autopilot hardware).
•
Standard
: provides the normal level of
acceleration (available on non-
Performance All-Wheel Drive vehicles and
Rear Wheel Drive Model S vehicles
equipped with Autopilot hardware).
•
Sport
: provides the normal level of
acceleration (available on Performance
All-Wheel Drive vehicles).
•
Insane
: increases peak torque by
approximately 30 percent (available on
Performance All-Wheel Drive vehicles not
equipped with the Ludicrous upgrade).
•
Ludicrous
: increases peak torque by
approximately 60 percent (available on
Performance All-Wheel Drive vehicles
equipped with the Ludicrous upgrade).
•
: increases peak torque by
approximately 30 percent (available on
Performance All-Wheel Drive vehicles not
equipped with the Ludicrous upgrade)
while also heating up the Battery to its
ideal operating temperature to ensure
access to 100% of available power. Before
choosing this setting, read about
.
•
Lu
: increases peak torque by
approximately 60 percent (available on
Performance All-Wheel Drive vehicles
equipped with the Ludicrous upgrade)
while also immediately heating up the
Battery to its ideal operating temperature
to ensure access to 100% of available
power. Before choosing this setting, read
about
.
NOTE:
Although Chill does not directly
improve driving range, using the increased
torque and power available in Insane or
Ludicrous mode can reduce range and
efficiency.
NOTE:
When Chill is selected, Chill displays
on the instrument panel above the driving
speed.
In addition, a Performance All-Wheel Drive
Model S also features Launch Mode to
provide optimum acceleration on surfaces
with good traction. For the specific driving
instructions required to use Launch Mode, see
.
To choose an acceleration mode, touch
Controls
>
Driving
>
Acceleration
.
Using or Lu
If you choose Insane or Ludicrous, additional
power is available immediately. However, to
achieve the absolute maximum power
(designed for short term use), you can choose
or
Lu
to heat the Battery to
its ideal operating temperature. This ensure
access to 100% of available power.
While the battery is being heated, the
touchscreen displays a status message
providing you with an approximate wait time,
and letting you know when the additional
power is available. In addition to heating the
Battery,
and
Lu
modes strive
to keep the Battery within an optimal
temperature range. Therefore, under
aggressive driving scenarios, you may also
see the “Cooling” status for several minutes
until temperatures fall. Model S stays in the
chosen mode for three hours, even if you
leave the vehicle. After three hours, the
feature times out.
NOTE:
and Lu are designed
to achieve maximum performance for short
term acceleration. These settings are not
intended for daily driving. The tradeoff for the
additional power boost is extra energy
consumption and earlier power fade on long
drives. The Insane or Ludicrous acceleration
settings provide a significant increase in
performance even without choosing the
or Lu setting to achieve
maximum Battery power. In fact, in normal
driving situations, the additional power that
can be achieved using and Ludicrous
+ may be unnoticeable.
NOTE:
To support or Lu, the
charge level must be 20% or higher. You
cannot initiate these settings if the charge
level is less than 20%. In addition, these
settings immediately cancel if at any time
during use, the charge level drops below 20%.
Acceleration Modes
76
MODEL S OWNER'S MANUAL