2. Remove the battery by lifting it away from the
retaining clips.
3. While avoiding touching the battery's flat surfaces,
insert the new battery (type CR2330) with the ‘
+
’
side facing up.
NOTE:
Wipe the battery clean before fitting and
avoid touching the battery's flat surfaces. Finger
marks on the flat surfaces of the battery can reduce
battery life.
NOTE:
CR2330 batteries can be purchased from any
retailer that sells batteries.
4. Holding the bottom cover at an angle, align the tabs
on the cover with the corresponding slots on the key
fob, then press the cover firmly onto the key fob until
it snaps into place.
5. Test that the key fob works by unlocking and locking
Model S.
WARNING:
Key fob batteries contain a chemical
burn hazard and should not be ingested. The key
fob contains a coin cell battery. If the coin cell
battery is swallowed, it can cause severe internal
burns within two hours and can lead to death.
Keep new and used batteries away from children. If
the battery compartment does not close securely,
stop using the product and keep it away from
children. If you think batteries might have been
swallowed or placed inside any part of the body,
seek immediate medical attention.
Managing Keys
To display a list of all keys (phone keys, key cards, and
key fobs) that can access your Model S, touch
Controls
>
Locks
. An icon displays next to each key to indicate
whether the key is a phone key, key card, or key fob. Use
this list to manage keys that have access to your
Model S. To add or delete keys, see
Model S supports up to 19 keys. When you reach this
limit, you must delete a key before adding a new one.
NOTE:
You can use the same key for more than one
Model S. This prevents you from having to deal with
multiple keys when you switch vehicles. If you customize
the name of an authenticated key card or key fob on one
Model S (by touching the pencil icon), any other Model S
to which the key card or key fob is authenticated also
displays the changed name.
Adding and Removing Keys
To add a new key card or key fob:
NOTE:
When adding a key fob, ensure it is at room
temperature. Pairing a key fob that is very cold can be
unsuccessful.
1. On the touchscreen, touch
Controls
>
Locks
then
touch
+
in the Keys section.
2. Scan your new key card or key fob on the card reader
located on the wireless phone charger. To scan the
key fob:
◦
Place it at the top of the left phone charger,
against the center divider.
◦
Point the front of the key fob down.
◦
Swipe downwards (as shown in the image).
When you hear a chime and the new key is
recognized, remove it from the card reader.
3. Scan a key card or key fob that has already been
paired to the vehicle to confirm new key pairing.
Keys
11
Opening and Closing
