Tesla CM5220SW, User Manual

Page: 28 / 252

28
ENG
Cleaning And Maintenance Of The Oven’s Front Door Glass
Rack Positions
It is important to place the wire grill into the oven
properly. Do not allow wire rack to touch rear wall of
the oven. Rack positions are shown in the next figure.
You may place a deep tray or a standard tray in the
lower and upper wire racks.
Installing and removing wire racks
To remove wire racks, press the clips shown with arrows in the figure, first remove the lower, and than the upper
side from installation location. To install wire racks; reverse the procedure for removing wire rack.
Changing The Oven Lamp
WARNING!
To avoid electric shock, ensure that the appliance circuit is open before changing the lamp. (having circuit open
means power is off) First disconnect the power of appliance and ensure that appliance is cold.
Remove the glass protection by turning as indicated in the figure on the left side. If you have difficulty in turning,
then using plastic gloves will help you in turning.
Then remove the lamp by turning, install the new lamp with same
specifications.
Reinstall glass protection, plug the power cable of appliance into electrical socket and complete replacement.
Now you can use your oven.
Remove the profile by pressing the plastic latches on both left and right sides as shown in figure 23 and pulling
the profile towards yourself as shown in figure 24. Then remove the inner-glass as shown in figure 25. If required,
middle glass can be removed in the same way. After cleaning and maintenance are done, remount the glasses and
the profile in reverse order. Make sure the profile is properly seated in its place.
Catalytic Walls*
Catalytic walls are located on the left and the right side
of cavity under the guides. Catalytic walls banish the
bad smell and obtain the best performance from the
cooker. Catalytic walls also absorb oil residue and clean
your oven while it’s operating.
Removing the catalytic walls
In order to remove the catalytic walls; the guides must
be pulled out. As soon as the guides are pulled out,
the catalytic walls will be released automatically. The
catalytic walls must be changed after 2-3 years.
Figure 23 Figure 24 Figure 25
Rack 4
Rack 3
Rack 2
Rack 1
Figure 26