Tescom RM2020, Installation And User Manual, Page: 7 / 15

6
2.3 Mechanical Installation
You can either install the remote monitoring panel on the wall or use on the table by placing on the
pedestal.
There are 2 connection points to install to the wall.
Dimension of installation points are given below.
2.4 Before Starting
Control the communication connection between UPS and more monitoring panel. (RS232 / RS485). If
everything is OK, plug the electrical cable of adapter. (Panel supply should be taken from UPS output.
Otherwise, panel power shall be interrupted during electrical interruptions).
3. STARTING
3.1 LCD Menu Structure
Menu structure is established on LCD panel to monitor UPS status information and measured parameters.
These menus can be roamed with the "menu selection button" and enter into menu content with the "enter" button.
Menu selection button is used again to monitor different parameters inside the menu. Menu names and monitorable
values are given at upper line on the LCD screen. UPS status information and alarms are monitored on the lower
line.
Values in the menu content vary depending on communication protocol of the device. Remote monitoring
panel automatically recognizes the communication protocol and varies values accordingly. It can communicate with
TX100 (1phase/1phase) and TX300 (3 phase/1 phase, 3 phase/3 phase) protocols. For instance, while voltage
value is indicated as single phase in menus depending on TX100 information, it is indicated as 3 phase depending
on TX300 protocol.
Menus and sub-parameters are indicated below.
220 mm