Tescom MTP200B, Operating Manual

Page: 71 / 172

MTP200B BT LE Signal Analyzer Set-up
55
10.2.3 Test Method Setting
Select either TEST_MODE or ADVERTISING mode according to test method.
●
Select ANL (M2) → CONFIG → TEST_METHOD tab → Set TEST_MODE or ADVERTISING
○
Select TEST_MODE for Direct Test Mode or Non-signaling test
○
Select ADVERTISING for Advertising test
For detailed explanation on BLE test, please refer to the 21. BLE Test Method .
Figure 10-3 TEST_METHOD Setting Screen
10.2.4 Test Case Setting
●
Select ANL (M2) → CONFIG → TEST_CASE tab → Select the item to be tested. For supported TEST_CAS
E item, please refer to the Table 10-2 BT_LE TEST_CASE .
For more details in measurement procedure and Specification on BLE test case, please refer t
o the 22. BLE RF Test Cases .