Tescom MTP200B, Operating Manual

Page: 70 / 172

54
MTP200B BT LE Signal Analyzer Set-up
4. Control PC: A PC may be used to control the remote program of MTP200B and DUT.
10.2 MTP200B BT LE Signal Analyzer Set-up
Set the test-related parameters such as channel, NUM_PACKET, TEST_CASE, and TEST_METHOD.
10.2.1 BT LE Mode Setting
●
Select ANL (M2) → CONFIG → BT_LE tab.
Figure 10-2 Setting Screen in BT_LE ANL Mode
10.2.2 Channel Setting
Select BLE channel to be measured.
●
Select ANL (M2) → CONFIG → CH_NUM → Set CH_NUM for the transmission channel of DUT.
Table 10-1 Table BLE Channel(CH) & Frequency(FREQ, MHz)
CH FREQ CH FREQ CH FREQ CH FREQ CH FREQ CH FREQ CH FREQ
0 2402 6 2414 12 2426 18 2438 24 2450 30 2462 36 2474
1 2404 7 2416 13 2428 19 2440 25 2452 31 2464 37 2476
2 2406 8 2418 14 2430 20 2442 26 2454 32 2466 38 2478
3 2408 9 2420 15 2432 21 2444 27 2456 33 2468 39 2480
4 2410 10 2422 16 2434 22 2446 28 2458 34 2470
5 2412 11 2424 17 2436 23 2448 29 2460 35 2472