Vacuum Cleaner User Guide
Operating your Vacuum Cleaner
1: Extend the power cord:
Gently pull the cord from the recess located in the rear of the cleaner. The
cord has two marks. The yellow mark shows the maximum safe length to
which you can extend the cord. If you can see the red mark the cord has
been lengthened too much. Never extend the cord beyond the red mark
or you may damage the cord winding mechanism.
2: To rewind the cord:
Unplug the cord. Press the cord rewind switch as indicated. Gently guide
the cord by hand into the cleaner until it is fully rewound. Do not let the
cord return unaided or it may whip and cause damage or injury.
3: Switch the Cleaner on
Press the Mains ON/OFF switch to switch the cleaner ON. (Press again to
switch the power OFF)
5: Adjust the Airflow
The suction can be fine-controlled by moving the airflow slider in the
hose handle.
When vacuuming:
Move the vacuum head back and forth over the surface. Use even
strokes. Do not press- let the cleaner do the work.
Using the Accessories
The Floor Brush
The Floor Brush can be used on
carpets or bare floors.
Bare Floors:
Press the side of
the lever with the Brush Sym-
bol. The brush will appear .
Carpets:
Press the side of the
lever with the Floor symbol to
retract the floor brush.
The Crevice Tool
The Crevice Tool is a dual-purpose tool. Use
it extended to vacuum down the side of
cushions, etc. Turn the head through 90º to
clean curtains, etc.
General Do’s and Don’ts
• Do NOT attach or remove accessories when the vacuum cleaner is
switched on.
• Do NOT pull the cleaner around the room by the hose.
• Do NOT over extend the hose. Trying to reach beyond the hose
length could cause an accident.
• Be especially careful on stairs.
NEVER clean stairs while standing
below the cleaner. Securely site the cleaner and stand at the same
level or slightly above the cleaner.
• Do NOT pull or carry the cleaner by the cord, close a door on the
cord, or pull the cord around sharp edges or corners. Do not over
extend the cord. Switch the cleaner off and move it to a closer
power point. Use just enough cord to do the job.
• Use the carry handle to lift or move the cleaner. If you are moving
the cleaner a long way or up a flight of stairs, switch off, rewind
the power cord and park the accessories.
• Examine the dust level and empty the dust cup regularly.
• NEVER let the dust exceed the MAX level
Clearing a Blockage
If the cleaner loses suction this may be due to clogged filters or a block-
age. DO NOT operate the cleaner if the suction is impaired.
If you suspect a blockage:
Switch off and unplug the cleaner imme-
diately. Empty the dust, check all the filters and clean them.
If this does not remove the blockage:
Check the hose, extension
tube and accessories visually and remove any blockage with a stick or
broom handle.
Page 5
1
3
2