PFR1614W
EN
4
Fit the motor section to the pedestal stand and
7.
tighten the thumbscrew.
Caution: The thumbscrew must be fully tightened before
the fan is operated.
Set the rear guard in the proper position (handle
8.
uppermost) and screw on the guard retaining nut
until tight.
Install the blade onto the shaft and screw on the
9.
blade retaining nut (counter-clockwise) until tight.
Place front guard onto rear guard.
10.
Secure both guards firmly by aligning the guard collar
11.
correctly and tightening the locking screw and nut.
CAUTION: DO NOT loosen the height adjustment screw
at any time during operation as this might result in
personal injury or damage to the appliance.
Front guard
Fan blade
Guard retaining nut
Handle
Motor shaft
Oscillation knob
Motor housing
Tilt adjustment knob
Thumb screw
Height adjustment screw
Speed control buttons
Rear guard
Stand cover
Clip
PVC sleeve (discard)
Blade retaining nut
Guard collar screw/nut
Blade retaining nut
Screw
Unscrew
