Instruction manual for MH & MH+M
94
(M
last block
– M
second last block
)/2
Two blocks of the list are
selected
The distance is calculated as follows:
(M
selection 1
– M
selection 2
)/2
14.14 Selection of a
measurement
block
In each measurement mode, it is possible to select one of the measurement blocks from
the measurements list. Selecting means to position the blue cursor on the measurement
block as it is the case for the last block on the below picture.
There are two possibilities to do so:
1. Use the arrows
and
of your control panel
2. Touch the block directly on the touchscreen
14.15 Two
measurement
blocks selection
When a calculation involves several measurement blocks, it is important to take into account
that the order in which the blocks are selected will have an impact on the final calculation
(on the sign of the result).
The multiselection of blocks is mainly used to calculate a height difference
or a
middle/average height
.
There are two different ways for a multiselection:
1. By quickly clicking two times on the block to be selected directly on the screen.
2. By displacing the focus (blue bar) on the block and pressing the key
of the keyboard.
Note that selecting a block will add a (1) or (2) after the number of the block (for example
M3 (1)). This number is crucial, as it directly depends on the order of selection and will play
a role in the sign of the result.
If you would like to deselect a block, you can:
•
Quickly click two times on the selected block (touchscreen)
•
Displace the selection on the block and validate the deselection
using the key
on the keyboard.
