Quick Start Guide for GeoBee v1.0
1
Quick Start Guide for GeoBee
!
Note: David GNSS receiver and Ntrip Modem TR600 are configured well
before shipping. Please set up the system according to Chapter 1, David
and Ntrip Modem TR600 are ready to work normally after power on.
1. GeoBee System Set up
Set up the GeoBee system following the figure below, and power up the system.
Figure 1: GeoBee System Set up
No.
Name
1
AX3702 GNSS antenna
2
TNC-J to SMA cable 25m
3
David GNSS Receiver
4
DC-2pin AC Power Adapter with 1.2m cable
5
COMM2-7pin to USB & DB9 male cable
6
COMM1-7pin to TR600-DC-2pin & DB9 female cable
7
Ntrip Modem TR600
8
4G antenna for TR600
9
Wi-Fi antenna for TR600
Note:
1) Accessing Internet via Ethernet is default while 2G/3G/4G is hot standby.
2) Using 4G antenna only when 2G/3G/4G SIM card is used.
3) For the known phase center coordinates of the AX3702 antenna, the configuration method
is as follows: use the ‘DB9 Female to USB Type A Male converter cable’ to connect the No. 5
cable in Figure 1 and a computer, open Tersus GNSS Center application on the computer, and
type below commands in the command window:
POSAVE OFF
FIX POSITION B L H
// B: latitude (degree), L: longitude (degree), H: height (m)
SAVECONFIG
1
2
3
4
5
6
7
8
Ntrip
Modem
SIM
Internet
12V
DC
DAVID
WiFi ANT
4G ANT
PC
9
