(with chuck pointed away from you) move the lever to the far left. For reverse rotation move the lever
to the far right. To activate trigger lock move lever to the center “off” position.
MOUNTING AND DISMOUNTING THE BIT
Mounting the bit
Loosen the sleeve by turning it toward the left (in the counterclockwise direction as viewed from the
front) to open the clip on the keyless chuck. After inserting a driver bit, etc., into the keyless drill chuck,
tighten the sleeve by turning it toward the right (in the clockwise direction as viewed from the front).
NOTE:
If the sleeve becomes loose during operation, tighten it further.
The tightening force becomes stronger when the sleeve is tightened.
DISMOUNTING THE BIT
Loosen the sleeve by turning it toward the left (in the counterclockwise direction as viewed from the
front), and then take out the bit
.
DRILLING
Place the bit on the work surface and apply firm pressure before starting. Too much pressure will slow
the bit and reduce drilling efficiency. Too little pressure will cause the bit to slide over the work area and
dull the point of the bit. If the tool begins to stall, reduce pressure slightly to allow the bit to regain
speed. If the bit binds, reverse the motor to free the bit from the workpiece.
TORQUE ADJUSTMENT
By turning the adjustment ring (Fig.1) the required torque can be adjusted. The arrow aligns with the
adjusted state.
Maintenance
WARNING:
To reduce the risk of injury, always unplug the charger and remove the battery
pack from the charger or tool before performing any maintenance. Never disassemble the tool,
battery pack or charger.
Disposal of the exhausted battery
WARNING:
Do not dispose of the exhausted battery. The battery must explode if it is incinerated.
The product that you have purchased contains a rechargeable battery. The battery is recyclable. At the
end of its useful life, under various state and local laws, it may be illegal to dispose of this battery into
the municipal waste stream. Check with your local solid waste officials for details in your area for
recycling options or proper disposal.
Disposal
Power tools, accessories and packaging should be sorted for environmentally-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
According to the European Directive 2002/96/EC on waste electrical and electronic equipment and its
incorporation into national right, products that are no longer suitable for use must be separately
collected and sent for recovery in an environmentally-friendly manner.
Summary of Contents for TPDC18134K
Page 1: ...User Manual Please read and retain for future reference Cordless Drill TPDC18134K...
Page 2: ...Exploded Assembly Diagram 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 2 17 1 17 3 18 19 1 19 2...
Page 14: ...ACL Group Intl Ltd Doncaster England Email info terratekintl com www terratekintl com...