Installation steps
● Insert the light sources of your choice into the appropriate socket. Take care of the maximum
allowed power level!
● The T5 fluorescent lamp is very fragile, handle with care!
installation of T5 fluorescent lamp
removal of T5 fluorescent lamp
● Place the prepared lamp fixture on top of the terrarium so that the light sources are down. Pay
attention to the position of the lamp fixture on the metal mesh or perforated metal plate on the top
of the terrarium. Light and heat must enter through it the terrarium!
● Fluorescent tubes are hazardous waste! Please do not dispose of in municipal waste, but in
designated waste disposal sites.
● If necessary, check the position of the silicone rubber at the bottom of the lamp fixture. This
ensures that the equipment is properly adhered to the glass parts of the terrarium.
● Connect the mains power cord and turn it on.
● If you want to use the heating function, connect a heater (heating cable, heater rock, heater plate)
to the heating output and place the sensor at the point of the terrarium where you want to
measure the temperature and humidity. Connect the sensor plug to the socket on the rear of the
lamp fixture. To achieve the set temperature only the heater output is actuated by the controller, it
does not affect the light or heat source connected to the timed sockets!
● Make sure that no water (splashing, dripping) reaches the sensor!
● Do not expose the sensor to direct heat radiation!
● Do not expose the sensor to direct UV radiation!
● If the temperature and humidity are not displayed, please contact us. Without the sensor, the
controller can perform timer tasks (E27 left, E27 right, T5 and humidifier sockets).
● In the menu system, set the desired on / off times, temperature and humidification frequency for
each socket. For information on menu options, see
● The humidifier output only works between
Sunrise
time and
Sunset
time.
● Check the temperature in the terrarium several times a day to prevent harm to the animal. If the
area is too hot, adjust the heating settings in the menu system and / or use a lower power heat or
light source.
● Remember to adjust the settings to the needs of the animal in the terrarium. Check with your
dealer or breeder.
12/15
Document number:
TC-HUJJ-2020/02-EN v3.3
