terrapin T101P, User Manual, Page: 3 / 5

•
Base Station should beep while button on Panic Button [see diagram] is depressed and for a few
seconds thereafter
•
repeat with the Panic Button at other locations in the desired coverage area
•
after testing, Base Station should be returned to Active Mode [see Safety Turtle User Guide]
11. [optional if 10. successful] Repeat 10. with the Base Station in Active Mode [amber light off]. Once Base
Station alarms, press moon-shaped button to turn off.
12. If the Base Station has not so far beeped or alarmed, it needs to be relocated where there is better reception
of the signal from the Panic Button. See “Locate the Base Station” in Initial Setup and Testing section of the
Safety Turtle User Guide. Note that more than one Base Station can be used to expand coverage.
13.
If the system functions in Active Mode but not Test Mode, the CR2032 battery in the Panic Button
needs replacing [see Safety Turtle User Guide].
Installing the battery:
1. Separate the top and bottom halves of Panic Button and release battery from holder as shown below.
Replace.
2. Reattach the top and bottom halves of Panic Button.
3. Retest the Panic Button.