Terradonis is a registered trademark of ICS
ZA de Croix Fort - 12 rue du Soleil - 17220 La Jarrie
- France -
Tel: +33 5 4635 2828, Fax: +33 5 4635 2829
www.terradonis.com
seTTinGs
➜
Lubricate all rotating parts except the seed roller.
➜
The brush, the guide plate, the spongy rubber of the transmission wheel
and the spongy rubber of the compaction wheel are consumables.
Check them regularly and replace as necessary.
➜
Make sure the seedbed is uniform.
➜
Check whether the seed roller is caked in dirt, pesticides or seed
casing residues. If it is, it should be cleaned.
➜
Prepare a seedbed by carefully hoeing and levelling.
➜
When you sow beans or grains, a bypass can occur in the seed
hopper. In this case, gently tap the hopper and fill the hopper
half full instead.
➜
When you disassemble the sower, make sure the free roller
is not caked in dirt, etc. ...
➋
Let it slide along
the axles. Graduation
bar can help to settle
the distance according
to your need.
insTrucTions For use
➜
BRuSh:
In its default position, the brush lightly touches the seed roller.
To increase the volume of seeds, put the brush in a high position
(loosen the wing nut and lift the brush).
If you use coated seed:
The brush should touch the seeds, and exercise slight
pressure on them. It is necessary to find the right adjustment for your seeds, because
if the brush is too low, it will wear very (too) quickly. If it is too high, the seeds will
break.
➜
GuIDe PlAte:
The guide plate forms
a cavity between the roller, the brush
and the guide plate.
Without this space, the seeds might break.
The end of the guide plate
must be in close contact with the roller.
If the guide plate becomes misaligned,
you can realign it using the diagram opposite.
In a general way, guide plate should be removed
as soon as the brush is raised.
➜
SeeDING DIStANCeS:
The distances between the seeding can be adjusted by
adjusting the pinions and the number of holes in the roller,
see the seed distance table.
note:
the actual planting distances may vary depending on soil quality and speed
of work. Test intervals based on the ground before you start planting.
seTTinGs
Opening
Guide Plate
➜
ADJuStmeNt Of INteR-ROw DIStANCe:
4
5
➊
Unscrew
the wing bolt in
order to release
the seeding
element.
