13
Figure 25. Date and time settings.
”Local Time” shows the time of the device that it currently has, estimating possible DST offset. If the time in
this field is not correct, make sure you select the correct country (see section 5.6.10). Date and Time Source has
two options: NTP Server and Manual Input. In case of an NTP server, at least one server URL must be specified.
Make sure the IP settings (section 5.5.1) are correct and the device can access the NTP server. After clicking
“Update”, the device will try to connect to the server and update the local system time. The device will
synchronize the time automatically later on.
The “Manual input” option can be used for testing only, because it will never be synchronized to any external
time source and the time will be reset if the power supply will be disconnected.
5.6.12 Device information
Information about the device is shown in this submenu table (see Figure 26). You can check the software
version, time and other useful information about the system.
Figure 26. Device information.
6. Reset button
The reset button has different functions which mainly depend on the duration of the press.
•
Device reset
A short press (less than 2 seconds) will restart the entire system.
Red
-
green
LED indicates acceptance of this
command. This corresponds to section 5.6.7 “Restart the device - Full restart“ function.
• IP reset
Pressing the button for 2-5 seconds will activate the IP reset function. A flashing
red
-
green
LED will indicate an
activated IP reset command. It will enable the DHCP option (device IP address will be assigned by the network
router) or set the address to 192.168.1.10 if the router does not exist. WEB interface port will reset to the default
value 80. A full reboot of the device will then be performed.
•
Restore defaults
Pressing the button for longer than 7 seconds will activate the “Restore defaults“ function.
Red
blinking LED will
indicate an activated command. After releasing the button, all device parameters will be restored to their default
values, and the application will be restarted. IP settings will not be restored to defaults.
• Restore firmware to factory version
