Installation and Operating Guide
High-
IonBar™ (Ionizing Bar)
©
Copyright 2016 Terra Universal Inc. All rights reserved.
• Revised November 2016 • Document No. 1800-45
Terra Universal, Inc. • TerraUniversal.com • 800 S. Raymond Ave. • Fullerton, CA 92831 • TEL: (714) 578-6000 • FAX: (714) 578-6020
5
3.0
Maintenance
Disconnect the unit from the power supply before servicing.
WARNING
The IonBar™ requires little maintenance beyond occasional cleaning. Frequency of cleaning depends on the
cleanliness of air in the immediate vicinity of the IonBar™.
The emitter housing may be cleaned using alcohol or other mild detergent and de-ionized water.
If deposits are observed on the emitter tips,
1.
Disconnect the IonBar™ from system power.
2.
Use a cleanroom swab moistened with a cleaning solution of 50% isopropyl alcohol and 50% de-ionized water to
remove deposits from the emitter points.
3.
If deposits cannot be removed, or if the tips appear worn or bent, the IonBar™ may not discharge surfaces with
optimal efficiency. In this case, replace the tips. Use a pencil eraser or needle-nosed pliers to remove the old tip.
Insert the new tip and gently press until it seats against the connector; no twisting is necessary.
4.0
Specifications
Replacement Parts
Product
Catalog #
120VAC Power Transformer
2005-09A
220VAC Power Transformer
2005-09A-220
Replacement Titanium Emitters
2005-45
Low-Voltage Power Cable
2005-27
General IonBar™ Specifications
Construction
Exterior
PVC
Emitters
Machined titanium; 3-year estimated life
(Field replaceable)
Emitter Output
12,000V
Power Ratings
System Power
24 VAC
Input Power (Wall Transformer)
120/220VAC, 50/60Hz
Current Draw
104 mA (44” model)
Performance
Static Decay Time
Discharge times directly under the IonBar™
average 28 seconds (from ± 1,000 volts to 100
volts), measured in a 4-foot laminar flow hood
with air speed of 90 feet/minute.
