LIMITED PRODUCT WARRANTY INFORMATION: This Product comes with a ONE (1) YEAR Limited Warranty from the date of retail
purchase by the original end-user. If a material or workmanship defect arises and a valid claim is received within the Warranty Period, this
Product will be replaced. Mobility Holdings cannot be held liable for damages to personal property due to misuse or improper care and
maintenance. This Product Warranty does not, under any circumstance, cover the replacement or cost of any third party product used with
or connected to the Product.
Tern, the Tern Werd (logotype), and the Tern Berd (device) and Market Basket, used alone or in combination are trade names, trade
devices or registered trademarks of Mobility Holdings, Ltd.
© 2018 Mobility Holdings, Ltd.
Mounting the Basket
2. Remove spring rods and levers.
1. Loosen screws of brackets with
Cross-Head Screwdriver.
Changing Mounting Orientation
1. Please take note that the basket has
red indicators only on one side of the
basket. Rest the side with the red
indicators on the rack.
2. Set the basket down and check if the
levers can close. If not, change the
position of the levers anywhere along
the spring rod and test again.
Ensure that no objects, such as strap
holder, prevent the levers from
closing completely.
3. Close the levers and make sure the
levers click inwards. Please note that
the rack tube may sit at different
locations on the TopKlip on the
non-red side of the basket.
Make sure that the basket is securely
mounted before riding.
3. Place one bracket in the mounting
holes in the desired mounting
orientation.
Note the location of the red
indicators relative to the edge of
the mounting plate. Incorrect
orientation will result in basket
being off-center.
Load Capacity
Maximum load capacity: 10 kg (22 lb)
6. Install the other bracket.
7. Tighten the screws (Max 2 Nm).
4. Reinsert the rods into the bracket.
Check the diagrams on the front to
determine which position to set the
rods in the brackets and levers.
5. Tighten the screws (Max 2 Nm).
7. Slide the rubber retainer rings
against the brackets.
CLICK!
CLICK!
