Teridian 73M1966B, User Manual, Page: 11 / 19

UM_1966B_024 73M1966B Evaluation Kit User Manual
Rev. 1.0 11
3 Connectors and Jumpers
This section describes the connectors and jumpers on the 73M1966 Demo Motherboard.
Table 1: Motherboard Connectors and Jumpers
Connector
Number
Name Function
S1 4-pin daughterboard
connector Socket for the analog interface to the 73M1966B Demo Board.
S2 20-pin daughterboard
connector Socket for the digital interface and power to the 73M1966B Demo
Board.
J1 VCC3.3 Banana jack for 3.3V lab supply connection. (Use either J1 and J2
or J5 but not both.) Using J1 and J2 is necessary only if testing
over a range of voltage.
J2 GND Banana jack for ground lab supply connection. (Use either J1 and
J2 or J5 but not both.) Using J1 and J2 is necessary only if testing
over a range of voltage.
J3 To Slave Connector to connect SPI to slave demo board.
J4 From Master Connector to connect SPI to master demo board.
J5 +5 V Power Input for +5 V power supply which is down regulated on the
Motherboard to 3.3 V. (Use either J5 or J1 and J2 but not both.)
J6 PCM Highway Header connector to the PCM Highway.
J24 CLKO BNC connector for the clock output.
J30 RJ-11 Connector Connection to telephone network simulator.
J31, J32 PCM Highway PCM Highway connectors for daisy chain operation. Only used to
daisy chain two or more Motherboards.
J33 Reserved
J41 Reserved
J42 SPI Connector Connect the cable from the PC to J42 to communicate to the SPI
via the GUI. Take care to observe the orientation of the connector.
J43 CLKI BNC connector for connecting an external PCM clock source or
sync.
J44 FS BNC connector for providing or receiving PCM frame sync..
J45 DR BNC connector providing receive data from a PMC source to the
demo board.
J46 DX BNC connector providing transmit data to a PCM receiver from the
demo board.
J47 Audio Install jumper on the AUDIO pin and the middle pin to activate the
speaker amplifier. By default, no jumper is installed and the
speaker amplifier is not activated.
J57 On-Board Oscillator Install jumper to enable the on-board oscillator. This is not
normally used.