RISK ASSESSMENT
QPP147
Section 1
Rev. March 07
C4.
Slips, trips and falls when
getting on or off the plant.
C4.
Take the following precautions when you get in and off the crane.
a.
Check that all guards and covers on the machine are fastened correctly. Tighten any
loose bolts or repair any damage.
b.
Wipe off any mud, oil or snow on the steps before you start work.
c.
Do not jump onto or off the machine.
d.
Do not hold onto the seat, control box, control levers or anything other than the hand-
grips provided when you get on or off the machine.
e.
Do not get on and off the machine while it is moving.
C5.
Dropping of load
C5.
Check safety devices. The AT-20 & MAC-25 are fitted with an over-hoisting detector and
other safety devices which should be checked before starting work.
C6.
Crane overload or tip over in
adverse working
configuration.
C6.
Check the operation of weigh gauge according to the pre-operational check procedure
described in the weight gauge Operation Manual (this manual should be kept in the Cab).
C7.
Failure of controls and/or
mechanical parts of plant.
C7.
Before operating the crane check the machine according to the pre-operational checking
procedure detailed in this Manual, and check the operation of the control levers while the crane
is not carrying any load.
Allow the crane to warm up before carrying full load.
Ensure that the crane is serviced regularly in accordance with the requirements in this manual.
Summary of Contents for Franna AT-15
