Terex Fermec 760, Service Training, Page: 77 / 116

73
MASTER CYLINDER (2-wheel steer machines AGCO Axles)
Removal
NOTE : There are two master cylinders, connected by
a balance tube and compensator valves. Removal of
one master cylinder is described here.
1. Park the machine on a level surface. Raise the
loader and lock the support strut to hold the
loader. Place blocks under the rear wells and
stop the engine.
2. Open the hood.
3. Inside the cab, remove the trim panels from around
the brake pedals to access the brake master
cylinders (1).
4. Remove the clevis pin (9) that fastens the clevis
(10) on to the master cylinder (1) to the brake
pedal.
5. Clamp the flexible hose (2) between the brake
reservoir and the inlet pipe assembly (3).
6. Release the hose clip (4) and pull the flexible
hose (2) from the inlet pipe assembly (3).
7. Disconnect the inlet unions (5) from BOTH
master cylinders (1).
8. Remove the inlet pipe assembly (3).
9. Disconnect the pipe (6) from the pressure port of
the master cylinder (1) to be removed.
10. Disconnect the balance pipe (7) from BOTH
master cylinders (1).
11. Remove the 2 nyloc nuts (8) and the master
cylinder (1).
Installation
NOTE : The installation of the master cylinder is the
reverse of the removal.
1. Set the clearance of the master cylinder push
rod, so that when the brake pedal is against its
return. Stop the push rod does not pre-load the
brake master cylinder.
2. Replenish the brake reservoir with the correct
grade of fluid.
3. Adjust the brakes.
4. Purge air from the brake system.
CS98F513
1
7
9
10
8
6
3
5
2
4
Contents