DP17 Flush Mount DP Display Unit/Transmitter-Operation Manual
Edition:A/1
2
Connection
Different models have different electrical terminals. Please wire specific model according to the wiring diagram.
DIP switch
Jumper “1” and “2”: response time settings, 0.5(default)/1/5/10 s.
Jumper “3”: LCD backlight setting, ON means backlight on, OFF means backlight off (default).
Jumper bit “4” and “5”: engineering unit setting, Pa(default)/mbar/mm wc/in wc
It should be power OFF during installing and wiring. When using 24VAC, it is strongly recommended to power the unit with
independent transformer. If sharing a 24VAC transformer with other equipments such as controllers, transmitters or actuators,
please make sure the terminals 24V and GND are connected correctly. Otherwise, it will perhaps reduce serious damages.
Before power on, make sure to complete all input / output / communication connections, dial switches and jumpers. There is a
self-inspection process of around 30 seconds after powering on, before it goes into normal working status.
I
nstallation
A
POWER SUPPLY
24V AC/DC
ON
Output GND V- V+
1 2 3 4 5 6 7 8 9 10 11
1 2 3 4 5
DIP switch
ON
1 2 3 4 5
ON
3 3
ON
sw
without
backlight
with
backlight
ON
4 5
sw
Pa mbar mm wc in wc
ON
4 5
ON
4 5
ON
4 5
ON
1 2
sw
0.5S 1S 5S 10S
ON
1 2
ON
1 2
ON
1 2
