![Terasic SDI-FMC User Manual Download Page 46](http://html1.mh-extra.com/html/terasic/sdi-fmc/sdi-fmc_user-manual_1088486046.webp)
SDI-FMC User Manual
45
April 22, 2019
host PC with a Mini USB cable.
5.
Power on the HAN pilot platform.
6.
Make sure the Quartus Prime and the USB-Blaster II driver has been installed on the host
PC.
7.
Copy the folder Demonstrations/HAN_12G_SDI/demo_batch from the SDI-FMC System
CD to the host PC and execute “test.bat”.
8.
Observe LED0 and LED1 as shown in
. If two LEDs light up, it means the two
channels 12G SDI loopback test are pass.
9.
Set the SW0 switch to Down as shown in
and observe HEX0_DP (dot point). If
the dot point lights up, it means the 3G SDI Loopback test is pass. Then, set the SW0 switch
to the Up position, and observe the HEX1_DP to check whether the 3G SDI loopback test is
pass in another direction.
10.
summarized the functional keys and details of each LED status.
Figure 4-13 Make sure FMC_VCCIO(JP2) is set to 1.8V
Figure 4-14 KEY/SW/LED on HAN
Summary of Contents for SDI-FMC
Page 1: ......