Terasic Apollo Carrier Board, User Manual

Page: 19 / 55

Apollo Carrier Board
User Manual 18 www.terasic.com
September 22, 2020
2 JSOM-B 4
3 JSOM-T 4
4 Hex Nut 4
Table 3-2 Tools for Assembly
No. Description QTY
Photo
1 Philips Screwdriver 1
2 1.5mm Hex Key 1
3 5.0mm Hex Socket 1
3.2 Assembly
Below are the procedures to assemble the Apollo S10 SoM and Apollo Carrier Board or user can
refer to the video
“
How to assemble Apollo S10 with carrier board
” to assemble the board.
1. Use Philips Screwdriver and 5.0mm Hex Socket to screw four M2.5 Screws into four
JSOM-B on Apollo S10, as show in Figure 3-2.
2. Use a Hex Key to screw four JSOM-T into four JSOM -B as shown in Figure 3-3 .
3. Place Apollo Carrier Board over the four TSOM-T as shown in Figure 3-4 .
4. Press Apollo Carrier Board and Apollo S10 to combine the FMC connectors tightly,
JSOM-T is bulged on the Apollo Carrier Board as shown in Figure 3-5 .
5. Use a Hex Key to screw four Hex Nut into the four TSOM-T as shown in Figure 3-6 .