Using PCoIP Host Cards w ith VMw are View
TER0911004 Issue 2
14
7.
Click
Upload
.
8.
A warning appears. Click
OK
to start the upload. This operation may take a few minutes.
9.
The following message appears when complete: “Success Flash successfully
programmed!” Click
Reset
to reset the device for the changes to take effect.
10.
A warning appears. Click
OK
to proceed.
11.
Repeat steps 3 through 8 on the client, but
do not
reset or power cycle the client.
12.
Restart the host.
13.
Reset the client.
14.
The new firmware is installed. You can now start a PCoIP session.
2.4
Installing PCoIP Host Driver Software Release v3.3.20
for Windows
The functionality described in this document requires PCoIP host driver software v3.3.20 or
later. Verify that the PCoIP host driver software installed on the host PC is using the correct
release. See section 5 for details on the host software installation process. You can download
the latest host driver software package from the
.
2.5
Ensuring your Operating System Complies with
VMware View
Ensure that you are using an operating system that is supported by VMware View. See the
