4. Installation guide
4.1 Hardware setup
The Terabee 3Dcam 80x60 is shipped with a USB 2.0 Micro Y cable to provide an
appropriate amount of power to the camera. Please note that using only one cable may
affect camera performance.
Connect the Micro USB cable
(micro B side) into the camera's USB port.
Plug the other two ends of Micro USB cable into your
PC USB port.
You've successfully completed the hardware setup.
Copyright
©
Terabee 2019
Terabee, 90 Rue Henri Fabre
01630, St Genis-Pouilly, France (next to CERN)
9/17