Tera TR-7200 VHF, User Manual

Page: 45 / 58

45
Care and Maintenance
Question and Answer
Condition Analysis Solution
The equipment can
not be powered on.
The battery may be improperly installed. Remove the battery and attach it again.
The battery may be fully discharged. Recharge or replace the battery.
The battery may suffer from poor contact
caused by dirty or damaged battery
contacts.
Clean the battery contacts. If the problem can not
be solved, contact your dealer or authorized service
center for inspection and repair.
During receive
operation,
incoming voice is
weak, intermittent,
or not present.
The battery strength may be too low. Recharge or replace the battery.
The volume may be set to a low level. Increase the volume.
The antenna may be loose, or may be
improperly installed.
Power off the radio, and re-install the antenna.
The speaker may be blocked or damaged. Clean surface of the speaker. If the problem can not
be solved, contact your dealer or authorized service
center for inspection and repair.
You can not
communicate with
other members.
The frequency or signaling may be
inconsistent with that of other members.
Set your TX/RX frequency and signaling to the same
as that of other members.
The channel type (digital/analog) may be
set inconsistently.
Make sure all members are on the same digital/
analog channel.
You may be too far away from the group
members.
Move closer towards other members.
Irrelevant
communications or
noises are heard
on the channel.
You may be interrupted by radios using the
same frequency.
Change the frequency, or adjust the squelch level.
The radio may not be set with any private tones. Set tones for all member radios to avoid
interference at the same frequency.
TERA