PC22B Owner’s Manual
6
Step 4
A) Use the axle extended from bottom grid (P) to insert
the hole on the left back leg (N), one M8 flat washer
(EEE), one wheel (Q), one M8 flat washer(EEE) and
one M8 nut (FFF) by sequence, tighten the nut by the
wrench provided . Repeat the same procedure to
assemble the right back leg(O) and other wheel, insert
one wheel cap (R) on each wheel.
B) Insert the extended ends from bottom grid into the
holes on the two front legs (M).
C) Insert the four legs into the the four seats underneath
the bottom bowl. Align the holes on the seats with the
holes on the legs, insert one M5 butterfly bolt(GGG)
into pre- drilled hole, tighten the bolts by wrench
provided.
Step 5
A) Put the vent (I) in the ash receiver (J).
B) Align the holes on the vent with holes on the ash receiver
and the holes on the vent handle retainer(L), then insert the
vent handle (K) and the M 5 nut (JJJ) into the hole. Tighten
the nuts by hand.
Step 6
Slide the ash assembly into the guide underneath the bottom bowl.
