GSF3916
Owner’s Manual
8
Step 4 (Cart fill panel assembly)
a) Align each hole on the cart front panel (V)
with the holes on the upper front beam (P)
and cart base panel (R), then insert one
bolt (AA), one spring washer (CC) and one
flat washer (DD) into the holes and tighten
by hand until secure.
b) Go back and tighten all the bolts using the
screwdriver provided.
Step 7 (Assemble the body to the cart)
a) Place the body assembly onto the cart
assembly (A).
b) Align the holes on the four cart legs with the
holes on the body assembly (A), then insert
one bolt (AA), one spring washer (CC) and one
flat washer (DD) into each hole. Tighten by
hand until secure.
c) Go back and tighten all the bolts using
screwdriver provided.
Attention:
Unpack the regulator/hose
assembly (located underneath the
firebox) prior to assembling the grill body
to the cart, and pull out the
regulator/hose to the cart side panel
when go ahead to this step.
Step 5 (Door assembly)
a) Insert the bottom pin on the right door (X) into the
pre-drilled hole on the cart bottom panel (R).
b) Push down the top pin of the right door and insert it
into the pre-drilled hole on the upper cart front beam
(P).
c) Repeat the procedure for the left door (W) assembly.
Step 6 (Heat insulator assembly)
b) Align the holes on the heat insulator (U) with the holes on the cart back
beam.
c) Insert one bolt (AA), one spring washer (CC) and one flat washer (DD)
into each pre-drilled holes. Tighten bolts by hand until secure.
d) Repeat the procedure for the heat insulator with cart front beam.
e) Go back and tighten all the bolts using the screwdriver provided.
