Mesh Under-Clips
Attaching the inner mesh underneath the
base gives it the full seal. Start by passing
all the centre straps underneath to the
centre hatch. These can then be attached
to each other using the
3-way clip
. Finally,
there are
3 further straps
underneath each
corner inbetween the centre and the end
corner piece.
25
34, On one side of the
lower inner mesh is a
3-way connector clip.
35, Pass this underneath the
base towards the central
hatch of the Universe.
36, Pull in the corresponding
central straps in towards
this clip and secure.
39, Do a final check to ensure
all clips are fully attached.
38, Clip the 3 final straps
together.
37, Lift each corner and
secure/clip the remaining
straps underneath.
26
Order to connect:
RED = 1st
YELLOW = 2nd
BLUE = 3rd
