9.
If joining more than one unit together, your original unit
should have been assembled with ZTP uprights on one end,
as described in step 4. Simply continue adding shelf supports
and uprights to complete your additional units.
8.
If particle board decking (Ref. No. 6) or wire decking (Ref.
No. 7) was ordered, place the decking on each shelving level.
The decking should fit flush inside the shelf supports. If you
have purchased a single unit, your shelving unit is now
complete. For adder units, see step 9.
7.
Attach the shelf reinforcements (Ref. No. 5) at each level by
sliding them onto the rivets until centered. Tap down on the
reinforcements until they are seated firmly.
6.
Attach the remaining shelf supports at the desired shelf
levels, making sure that all shelf supports are completely
seated in the upright slots.
NOTE: If you have purchased additional shelf levels, the
shelf supports for the extra levels may also be inserted
at this time.
NOTE: Recommended
number of reinforements
per shelf are as follows:
48”w = 1 reinforcement
60”w = 1 reinforcement
72”w = 2 reinforcement
96”w = 3 reinforcements
