7.
Repeat steps 5 and 6 on the
opposite end of the unit. Then,
attach the two ends by placing
two left-to-right shelf supports
across the width of the unit as
in step 4.
8.
Continue placing shelf levels,
one level halfway between
the center shelf and the top,
and one level using the top
two keyhole slots. Make sure
all shelf supports are mounted
with the flat side facing up.
Place the plastic shelf post
cap (Ref. No. 5) over the top
of the exposed metal edges of
the upright post.
9.
Place one particle board shelf
(Ref. No. 4) in each of the five
levels of shelf supports. Slant
each piece slightly as it is
being placed to allow it to
fit between the uprights
and the shelf supports. Make
sure each piece of particle
board is seated between all
the edges of each of the shelf
supports and that the particle
board is laying flat when
finished. The shelving system is
now ready for use.
ASSEMBLY OF HORIZONTAL SHELVING UNIT
1.
First, follow assembly
steps 1-4 on the
previous page as well
as adding the plastic
shelf post caps. Next,
instead of stacking
the uprights on top
of each other as shown
in step 5, place the four
shelf supports in the
top two keyhole slots,
being sure that the
flat edge of each
shelf support is facing
up as described in
the earlier steps.
2.
Build the second unit
in the same manner as
the first unit, except this
part will only have two
levels. Use the shelf
supports to create the
top level using the top
two keyhole slots,
and the second level
using the bottom two
keyhole slots.
3.
Insert one particle board shelf at each of the five shelf levels, as
described in step 9 of the previous instructions. Then place the
two units together or use separately as desired. The shelving unit
is now ready for use.
NOTE: For stability, be
sure to always have a
shelf on the bottom
of both units.
NOTE: Units are meant for stand alone
only. For safety, NEVER double stack
multiple units on top of one another.
NOTE: Units are meant
for stand alone only.
For safety, NEVER double stack
multiple units on top of each other.
