9.
Stand the unit upright and place in the desired location.
Remove temporary bolts in frames and bolt to adjacent units
together through frames.
10.
Anchor units to wall or floor. The units are not intended to
stand free and may topple if not secured. Units standing
back to back should be bolted back to back.
8.
If joining a three wide unit beside another unit, temporarily
install only one bolt and nut into the third and sixth holes down
from the top of the outer frame(s) that will be joined to the
adjacent locker frame(s). The center locker frame can be bolted
complete. If the locker is just a stand alone three wide unit,
finish attaching the rames using thirty eight bolts and nuts.
Check and tighten all permanent bolts.
NOTE: If the temporary bolts are not removed
before the frames are joined side by side, the
frames will have a
1
/
8
“ gap between them.
7.
Place the frame and door assembly (Ref. Nos. 7 & 8) over the
locker body. Make certain that the body sides are inside the
frames not between the frames. Attach the top to the frame
header and the bottom to the frame sill using one bolt each.
11.
If units are not pre-numbered, optional number plates and
plastic covers (Ref. No. 9) may be attached using push plugs
(Ref. No. 10). Tennsco name plate (Ref. No. 18) is installed at
the factory. As an alternative, custom number or name plates
may be ordered from the factory. Your locker is complete.
NOTE: Care must be taken to assure that lockers
are set plumb and level before anchoring.
12.
If additional accessories were purchased such as End Bases/
Front Bases (for lockers with legs), Closed Bases (for lockers
without legs), Slopping Tops, and/or Combination Locks or
Grooved Key Locks, please see the instructions that came
along with those parts.
Header Bolt Hole
Frame Header
Frame
Sill
Door & F
rame
Assembly
